Baghban Hydraulic strips, inspects and rebuilds hydraulic pumps, motors and cylinders for construction, industrial and material-handling machines, then pressure-tests every unit before it goes back to your site.
Every unit that comes into the workshop is fully dismantled, cleaned and checked part by part before we decide what needs replacing. Nothing goes back together on a guess.
Axial and radial piston pumps, gear pumps and vane pumps — full teardown, wear inspection and rebuild with new seals, bearings and pistons where needed.
Orbital, piston and vane hydraulic motors used in track drives, swing gears and conveyors — rebuilt and bench-tested under load.
Re-sealing, honing and rod repair for hydraulic cylinders on excavators, loaders and cranes, using correctly sized seal kits.
Select the symptom you are seeing. This quick guide gives you a practical starting point before you call or send the unit in.
This is an initial guide, not a final diagnosis. We confirm the cause after inspection and testing.
Low pressure can point to worn rotating groups, internal leakage, a weak relief valve or contaminated oil. Avoid loading the machine until the pressure is checked.
Ask about this faultWe don't quote off a phone description — pumps and motors are stripped down first so the repair is based on what's actually worn.
You get a clear estimate after inspection, before any repair work begins — no surprise add-ons at collection.
Rebuilt units are run and pressure-tested on the bench so you're not the one finding a problem on site.
Based in Delhi and focused on it — you can reach us directly and get a real answer, not a call-centre queue.
Send us the make, model and the fault you're seeing via the enquiry form, call or WhatsApp.
We strip the unit, check every part and send you a clear repair estimate before starting work.
Worn components are replaced, the unit is reassembled to spec and cleaned for reinstallation.
Every pump or motor is pressure-tested on the bench before it's released back to you.
